 Guardian
40 kW
- Quiet,
powerful, liquid-cooled engine fueled by natural gas or
LP.
- A
standard weather protective enclosure protects generator
from harmful weather and also effectively reduces exterior
noise levels. Includes key locks for security.
- Built-in
charger maintains battery at optimum performance level.
- Automatic
safety shutdowns protect engine and generator in event
of low oil level or pressure, high temperature, low coolant
level, overspeed and/or overcrank.
- Automatic
seven-day exerciser runs the system for fifteen minutes
each week to maintain to running condition.
- Standard
200-amp remote-mounted automatic transfer switch with
service disconnect for fast and efficient unattended transfer
to generator when utility source fails. Housed in a NEMA
3R outdoor rated enclosure.
Generator
Set
| Model |
04992 |
| Rated
Power (kW)* |
LP
40 / NG 37 |
| 60
Hz Phase |
Single |
| Voltage |
120/240V |
| Amps
@ 120/240V, Single Phase 60Hz |
LP
333.3 / 166.6
NG 308.3 / 154.2 |
| Engine
/ Alternator RPM |
1800 |
| Engine |
3.9L
V6 |
| Fuel |
Natural
gas or LP gas |
| UL
2200 Listed |
Yes |
| CSA
Listed |
Yes |
| Main
Line Circuit Breaker |
200
Amp |
Dimensions
(L" x W" x H") |
76.1
x 33.5 x 42.2 |
| Unit
Wt. (lbs.)** |
1400 |
* Natural
gas and LP gas rating may decrease depending on btu content
of local gas supply. Proper sizing of tank/piping is required
to ensure full output. **
Includes Transfer Switch
Controls
| Start
/ Stop Control |
Cyclic
cranking: 7 seconds on, 7 seconds rest. 90 seconds overcrank
protection. |
| Automatic
Low Oil Shutdown |
Standard |
| Overspeed
Shutdown |
Standard,
70 Hz |
| Overcrank
Protection |
Standard |
| Automatic
Voltage Regulator with Over-Voltage Protection |
Standard |
| Engine
Warmup |
15
seconds |
| Engine
Cool-Down |
1
minute |
| Safety
Fuse |
Standard |
| Starter
Lockout |
Starter
cannot re-engage until 5 seconds after engine has stopped |
| 2
Amp Timed Trickle Battery Charger |
Standard |
| Auto
Switch |
Utility
failure/7 day exercise |
| Off
Switch |
Stops
unit. Power is removed. Control and charger still operate |
| Manual
/ Test |
Start
with starter control, unit stays on. If utility fails,
transfer to load takes place |
back
to top |
|
